camaro set up question

[ugot86d]

our pure stock rules have changed to say camaros must run equal size lowering blocks. i have always ran a 1 1/2 in on the left and a 3 inch on the right now i have to put a 1/1/2 inch on both sides most allowed by rules

before i set it on the scales do i need to add some height to the right front to help or do i need to lower the left front.
i just do not have alot of time tomorrow to mess with it on the scales was trying to get a direction on where to go before hand something i could start on tonight. my time at our shop with the leval floor and turn tables is very short i may have 30 min there tomorrow

[RCJ]

Make a small adjustmant to lower the l/f then raise the r/f front a small amount .Adjusting both side will keep your ride hieght closer to what they were.When it is on the scale adjust the l/f air pressure to see the differents it makes.