PDA

View Full Version : mastersbilt



luv2race
05-24-2010, 05:40 PM
On The Bar That Comes Back To Axle Tube From Your Lift Bar Are They Still Running The Same Bar? And If So How Many Inches From The Center Section Out Is It Located On Axle Tube? Thanks Alot

JTSjet
05-24-2010, 06:38 PM
what year is it? i'm not sure of the exact measurement, nor would i trust it would be the same from one car to the next. on an '04 and '06 between the center section and the birdcage, i believe it favors the birdcage half of the tube. i would go about setting it up by putting the car on jackstands and jacking the rear end up to simulate ride height. square the 5th arm the best you can to the bar that holds the 5th arm shock (parallel so that the 5th coil shock will be straight up and down). with the swedge rod or whatever connects the brackets for the 5th arm support, set the heim ends to the middle of the thread and clamp the bracket to the axle tube where ever the rod fits.
i'm not certain this is the correct way to do it but it's worked for me for several years.

luv2race
05-27-2010, 08:20 AM
thanks for info its a 99.