View Full Version : Hydraulic throw out bearing setup
08-01-2010, 05:35 PM
I'm getting ready to put in a clutch and I've got the instructions for the TOB from quartermaster on how to set the shims, but how can you tell if you shimmed it right or wrong? How do you know it doesn't isn't holding pressure on the fingers? This is my first time with one of these.
08-08-2010, 12:59 AM
on my i-stock, i just shim it to where there is a slight gap between the bearing and the clutch fingers (so it doesn't constantly run the bearing) then shim and adjust the linkage so it just barley releases the clutch all of the way. then adjust the pedal stop!
Powered by vBulletin® Version 4.2.0 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.