View Full Version : Plugging cam tower oil holes question.
Doug_Guilds
11-03-2010, 05:49 PM
I am wondering what is the reason for doing this? I know everyone does it and all but what is the exact purpose for it?
thegenerallee
11-03-2010, 06:39 PM
i not sure what you are saying in pluging the holes a lot of people weld a plate to the top of the towers for strength because the thin tops are the weakest point to the heads
A.Pinto
11-03-2010, 11:29 PM
I believe that some cam bearings are grooved on the non bearing side (makes installation easier, no oiling holes to line up). So if the hole on top of #2 and #3 aren't plugged, then a loss of oil pressure will result.
Powered by vBulletin® Version 4.2.0 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.