PDA

View Full Version : How to check for bent Lower A-arms?



Rocket_racing
12-05-2010, 09:27 AM
Any ideas how to check 1 piece Rocket lowers to tell if they are bent? We picked up a few of them at a swap meet, plus I have a few of our own that we replaced after some 'contact'. Just by looking at them, they appear to be ok, no weld cracks or paint cracks as far as I can tell.

Egoracing
12-05-2010, 12:13 PM
Measure a known good lower and then measure the others. The measurements should be pretty close. I would be suspect of anything 1 inch short but I have seen some new measure almost that far out when a change was made in the manufacturing for adjustability.