PDA

View Full Version : Fan Spacer problems



mqdirtracer57
01-08-2011, 12:37 PM
I am running an #8817 Edelbrock water pump. It has a 3/4 shaft out of the front. The concern I am having is when I install my w/p pulley,there is not enough of the hub protruding through the pulley to center up the fan spacer. I measured the pulley thickness and it is 5/16 thick. Any suggestions on how I can fix this concern. I have thought about ordering new serpentine style from KRC to replace my v-belt set up. Not sure if that would get me in the right direction...

racin6mod
01-09-2011, 01:19 PM
you only need 1/8 to 3/16 sticking out past the pulley to locate your fan spacer.it should fit tight to the pump shaft if not the spacer might be worn out. you could chuck the pulley up in a lathe and face off a 1/16th but that would only weaken the pulley.