RACR_73s
01-23-2011, 09:38 PM
1) What lower ball joints do they use(I was told you can get them at local auto parts store)? what about upper ball joints?
2) What are the correct upper A arm lengths?
3) Why would the use 7/16" bolts(car had them on it) instead of 1/2" to bolt the uppers onto chassis?
4) Almost all the heims/rod ends are junk on the car(only one usable one on all of the front end). What about these ebay item # 150522450369 ?
http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=150522450369&viewitem=&sspagename=STRK%3AMEWAX%3AIT
5) Any set up help would be appreciated. Starting out on swing arm. Peoria Speedway 1/4 mile banked. 550-600HP steel block/alum head engine. Told to start on the purple bar by a couple of respected LM drivers but spring # seem to be all over the map?
6) What has to be done to run 7" & 9" shocks?
7) Driveshaft length with a Falcon?
~Thanks~
2) What are the correct upper A arm lengths?
3) Why would the use 7/16" bolts(car had them on it) instead of 1/2" to bolt the uppers onto chassis?
4) Almost all the heims/rod ends are junk on the car(only one usable one on all of the front end). What about these ebay item # 150522450369 ?
http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=150522450369&viewitem=&sspagename=STRK%3AMEWAX%3AIT
5) Any set up help would be appreciated. Starting out on swing arm. Peoria Speedway 1/4 mile banked. 550-600HP steel block/alum head engine. Told to start on the purple bar by a couple of respected LM drivers but spring # seem to be all over the map?
6) What has to be done to run 7" & 9" shocks?
7) Driveshaft length with a Falcon?
~Thanks~