bert trans question

[OWM50]

been a while since I had to take the drive flange off the motor and I cant find my manual or remember if the flange had to be torqued to the motor... can someone help me out?

[cavemod]

yes it does the same torque figure as the flywheel or flexplate bolts dont forget to put some locktite on the threads
60-70 ftlbs.these numbers come from a haynes manual

[zachmckenzieracing]

i recommend that you tighten them to 65ft lbs. also you a little thread locker on the end of your bolts of security. dont go over board with the loctite. just a lil dab does it. using too much makes it a pain when replacing it. if too much is used, and the holes arent cleaned out, this may cause the bolts to not tighten correctly and vibrate loose.