PDA

View Full Version : ideas for push



racingdirt19
04-12-2011, 01:00 PM
I was hoping for some ideas, I am having some trouble with my car pushing through the corners.
I am driving a Barry wright 2004 chassis with a 2008 front end on it. It is a full bar car and the springs weights I am using are Left Front 550, Right Front 375, both rear 225. So far I have just been running on 1/4 miles.
Thanks

MasterSbilt_Racer
04-12-2011, 01:17 PM
Where is the push? Entry, middle or exit? Are you on the gas or off of it when the car pushes?

F22 RAPTOR
04-12-2011, 01:41 PM
I was hoping for some ideas, I am having some trouble with my car pushing through the corners.
I am driving a Barry wright 2004 chassis with a 2008 front end on it. It is a full bar car and the springs weights I am using are Left Front 550, Right Front 375, both rear 225. So far I have just been running on 1/4 miles.
Thanks

Give Barry a call. He's a super nice guy and extremely knowledgable. They have a factory Crate and Super team so they can better serve their customers.

Barry Wright Race Cars
403 Battleground Road
Cowpens, SC 29330

Phone: 864-463-4711
Fax: 864-463-8335

Tech Support: supertech@barrywright.com

racin6mod
04-12-2011, 05:35 PM
with that soft spring on the rf I'd bet it pushes on entry. guy's that drive harddd in to the corner seem to like the soft rf spring but I was never one to drive in that hard so I had to stiffen the rf spring to get the balance I needed.