View Full Version : grooving tires skimmed the cords???
35racing
07-05-2011, 06:22 PM
I went a little too deep grooving a hoosier wrs-2. I just skimmed the cords in a couple spots not by much but Im not sure if its safe to run or did I kill it??? Anyone have any insight on this for me? Thanks
zerolm
07-05-2011, 07:23 PM
I am no expert, but I have a rule of thumb for myself regarding this topic. If I cut close to half of the cord, it is done.. If I don't cut the cord at all, but I can see the shape of it through the rubber, no problem. If I just touch the edge of the cord, use judgement... I have done the same thing a few times, obviously.... Hope it helps some...
hpmaster
07-05-2011, 09:21 PM
If you didn't cut um I would run them.
35racing
07-06-2011, 06:37 AM
Thanks for the feedback!!
Powered by vBulletin® Version 4.2.0 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.