looking for an all aluminum motor!!!!!!!

[jtautobody]

let me know what you have info, price, pics and your location, thanks

[warrior14]

I HAVE AN all alum bulock motor 400ci dynoed at 785hp. will sell with drysump or without. asking $10000.00 without drysump and carb. asking $13,000.00 with everything. it has a braswell carb. 4 stage pump. 450 laps on motor. you can phone me at 606-305-5888 or for info on motor it would be best to call mike bullock at bullock rac engines 606-274-4455 the motor belongs to ridner racing

[ev36rayburn]

we have a fresh 388 cornett ford with zero laps on rebuild. its complete except carb. has crank trigger, dist, water pump, pulleys, plugs, wires etc. ready to put in and fire up. If interested i can get you specifics from my motor guy. we put new heads and all parts on them on with the freshen over the winter/spring. Motor has not been fired since. very smooth and driveable with good power. 11,000. located in central Illinois. This was once a bloomquist motor and then won tons of races in central Ill for Tim Lance. reply here or call me at 815-848-1241 Eric

[bizkit]

FRESH 430 All alum 13* heads latest technology
Brodix block (4.135 bore)
GB2300 heads
Crower crank (4.0 stroke)
Crower rods (new)
JE pistons (new)
Isky lifters (new)
Gear drive
CV pulleys
MSD dual dist.
19” GM fan blade
$15,000

Please call Dane @ 901-508-6523 or email
Dane@ohhendricks.com

[jtautobody]

anything????

[perfconn]

Hello, I was wondering if you are still looking for an engine? If so let me know. I may have one you are interested in or will be willing to locate you one. email@theperformanceconnection.com Thank you for your time!

[ABBYSMOMMY9ca]

less than 400 laps on brand new rotating assy, dart block , brodix heads, braswell carb, dynatech headers, 4 stage oil pump, bert bellhousing,oiltank/oberg ,oil lines +cooler, 7al msd +coil etc. $12500 call 304 756 3132

[crp27]

we have a custom race engines 13# 430, completely redone this winter .new rotating assembly,everyting new but block, head castings,oil pan,intake,rockers only have a few races on them.we have ran this engine 450 laps with no trouble and super strong.you can contact me or i will set you up with larry or jeremy at custom.14500

[KNM]

If you are looking for a start-up project, I have a 410 and a 430 that both need work. The 430 broke a rod, but did very minimal damage to the block. The 410 has some older Yates heads, but is a solid little motor. It pulled a lifter sleeve out of the block and needs some repair work, but I don't think it's too bad. Both motors are Fords, and were built and maintained by Dargie. Both are currently at his shop.

219-863-2546 if interested