Impala front suspension on a metric Malibu

[modfan000]

I know that people run this what's the plus side of doing it? and do you use the steering linkages off the impala also or the metric?

[3-6 Racing]

I would also like a parts list and description of what has to be cut and welded to put impala parts in a g body need a chassis project for this winter

[stock car driver]

Ive never seen or heard of this. It was brought up on here before and went no place.

[3-6 Racing]

Personally how would you correct a g body front geometry if you had to use stock appearing parts ie. no tubulars?

[bushracing67]

i used camaro spindles and 80s crown vic upper a-frames on one, it worked great, used some upper a-frame mounts that are sold for asphalt the bolt went straight down into the block and slid in and out to adjust caster/camber

https://www.lefthanderchassis.com/v2a/viewproduct_group.asp?idgroup=2513594

[swrracing99]

I have impala spindles on my car with a 1/2 ton chevy up ball joint allstar #all56208 and used the #all56206 in the lower control arm. I had to get the upper control arm for the large bolt pattern and weld in a sleeve in the lower control arm to fit the lower ball joint. Also a plus for your roll center the spindles are 1 1/4" taller than a metric spindle and alot tougher. I would have to say it was well worth the time the car seems to turn alot better through the corners.