halfast07
09-20-2011, 09:49 AM
Brand new CNC lightened Dart Little M block with 50MM Roller cam bearings,Billet main caps ,oil restrictors with a 4.125 bore.Lunati 4 inch crank, Oliver Billet Rods , CP Pistons, moly Rings, coated rod and main bearings.Custom 7-4-3-2 swap 50MM Roller camshaft, Morel ultra series roller lifters, smith bros .210 ball push rods, Hex-a-just billet timing set.Alum Pro Pan,CV Products timing cover,ATI Balancer with ATI pointer, Brodix 18*clone heads CNC Ported and then hand polished, comp radius valve job. REV 2.180 int valves 1.60 ex valves, Titanium retainers with super 7 locks, spring buckets and ISKY springs.T&D shaft rocker arms.Bowtie intake with complete porting, fabricated aluminum valve covers. Baker alky Carburetor. RACE fuel pump. .Edelbrock Magnesium water pump with aluminum Pulleys.Barnes 5 stage dry sump pump.ARP bolts and studs through out.no laps never run..built by Advanced Racing & Machine. Valve covers- intake and water neck are powder coated. Cost over 24k to build.this motor is complete and is less than most rebuilds!!