PDA

View Full Version : How much is too much?



Hagen14t
09-22-2011, 11:25 PM
Hey guys i have a quick question. I run a pinion plate that is the five hole plate and i am in the fourth hole down. I have been running about 7 inches of rake in it but im almost to the bottom on my frame side. My car has just been sliding the right rear tire and burning it off, i was wondering what to do? Should i go up with the pinion one hole or down with the frame a little or up with the frame or what do you think?

washeduptoo
09-22-2011, 11:40 PM
Is it a qc or 9in, if a qc try it 1-1.5 inches above center of pinion, 9in try at center of pinion. Good luck.

TeamGRT12x
09-23-2011, 03:41 AM
I would look into other areas to help with entry side bite. The J Bar is only going to have a minimal effect on entry. How much left rear bite, rear stagger, what right rear spring. 4 Bar/4 Bar? Are you jumping out of the throttle then chasing the car to the middle of the corner?