PDA

View Full Version : 355/409 short block



9modified
09-26-2011, 09:47 PM
I have a 355 short block assembly ready to mount heads, intake, and oil pan and go racing. This short block has approximately 200 passes in a 2800 pound drag car. And 15 races in a dirt modified 7 races since it was freshened. It has an Eagle rotating assembly balanced, with 6” H/beam rods and SRP dome 13.1 pistons. Will sale with or without cam and lifters and timing chain. The cam is a Lunati solid roller pt#638-50144 297/305 .640I .640E Rpm range 3800/7600 Lunati pop up lifters.
With cam and lifters 1,000.00 not a dime less don’t ask or waste my time.
Without cam and lifters 800.00 not a dime less don’t ask.

I also have a 400 block 817 splayed caps( decked 9.005) bored .040 over /4.165 Has deck plugs and steam holes plugged ARP main studs kit. This block has approximately 14 to 16 nights in a dirt modified. You can hear it run before I tear it down. Never sleeved or had hard block filler put in it. Has been ran on gas and never runs above 180 degrees. Clearance for 6” H/ Beam rod 3.75 stroke, has lifter valley prepped and smoothed for efficient oil flow. Priced at 800.00 not a dime less don’t ask or waste my time.
Buyer is responsible for pick up.
Thanks, Brandon

You can call anytime after 6:45PM
859-779-5672 cell
606-287-8586 home

38 bmod
09-27-2011, 11:48 AM
Where are you located?

9modified
09-27-2011, 04:10 PM
Where are you located?

Mckee, KY 40447

9modified
09-28-2011, 06:09 PM
Mckee, KY 40447

tooooooopppppppp

9modified
10-03-2011, 06:11 PM
Great 355 makes good power.