PDA

View Full Version : Grt???



hobbyracerbn2
09-30-2011, 08:56 AM
I WAS NEEDIN TO KNOW HOW TO SET THE REAR ALLIGNMENT ON A GRT,WITH THE CAR STILL UP ON JACK STANDS?? AND HOW LONG OF A DRIVE SHAFT DOES ONE USE..i HAVE A REGULAT BERT TRANS WITH NO BALL SPLINE??

Wheelman33
09-30-2011, 01:02 PM
Driveshaft should be 38 inches. What are you looking to align? 4-link rods, panard bar? What year car is it?

hpmaster
09-30-2011, 01:30 PM
call fast shafts first 800 622-6617. I had a 38" and it was too long and ripped the seal out FYI. He has a bullet proof way of figuring what you need.

hobbyracerbn2
09-30-2011, 04:12 PM
i believe its 1997 square tube car...i was needin to set the panhard bar from side to side??i got a 38' but i believe i could change the yoke to a smaller one to keep it from bottoming out

GRTLRBITE
10-01-2011, 07:49 AM
19 1/4 jbar and 17" and 15 for 4 bars

sj valley dave
10-04-2011, 01:58 PM
I was told by Skip that the 1998 and earlier cars ran a 18 1/4" J bar...the one with the 33" left axxle and 35" right axle..We ran 18/ 1/2" and left side was lined up corrrectly...Just a FYI..

hobbyracerbn2
10-05-2011, 12:17 PM
yea but that depends on when u move ur j-bar up and down u have to lengthn the bar or shorten it to keep it inlign cause right nowi have it in the 2nd notch on pinion and its just on a regular j-bar mount on frame...just needin to know what was the best way to lign ur rearend up the quickist..do u keep ur driver side tires inlign or the pass side??? thanx...And on the 5th coil i got a 300 lbs spring running on it how far do u think i should mount it on the arm??? im running a steel head steel block motor

CHUMBA
10-05-2011, 02:09 PM
get it right in shop, then measure from tork amr bracket to right underslung bar, get 1/2" round wooden dowel cut to that measurement, us it as a quick measureing tool after changes. then adj p bar. WE shorten or lenghten ours three complete turn for each 1/2 " bar adj. in height ( thats the heim on frame side ) hope this what your looking for.

hobbyracerbn2
10-05-2011, 03:05 PM
oh ok thanx

sj valley dave
10-05-2011, 03:26 PM
We are running the BSB frame mount and oinion mount which has an arc in the mounts so as you move the J Bar up or down at either end it doesn't effect the side to side movement. You should sight down the drives side as far as alignment goes...

MADCAPRACING22
10-05-2011, 07:43 PM
If you are from Cleveland, Tenn. then call Kent Hicks at Hicks Specialty Welding and he will set you up right on that GRT. He is the only dude who touches my GRT and mine will fly. Mine was a rolling chassis and he helped me get everything I needed. Besides Skip Arp ,Kent Hicks is the best GRT man around these parts!