PDA

View Full Version : Tighten 4bar car up on entry



CHRISTINE
04-25-2012, 03:23 PM
If you roll in off the gas do you still soften rf and or stiffen lf to tighten car? Or is it different since your not in the gas?

dirtnasty5r
04-25-2012, 03:30 PM
If you roll in off the gas do you still soften rf and or stiffen lf to tighten car? Or is it different since your not in the gas?

Adjust your right lower for corner entry. If it is to loose on entry. move your right lower down. If to tight move your right lower up.

kraftkar7x
04-25-2012, 04:04 PM
Stiffer lf spring will tighten you up on entry

TeamGRT12x
04-26-2012, 01:47 AM
Stiffen the left front by 50 pounds as said earlier. If you feel the front end is good, and cutting well, I'd try to strap the back end down by putting a little more J Bar angle in it or pulling the RR Wheel in an inch.

There are a variety of other changes you can try, but I'd start there. The others are going to effect exit.