View Full Version : Ball joints & S7 spindles.
HuckleberryB4
05-26-2012, 09:09 AM
We just put the new s7 spindles on our smackdown car and I was wondering if they use the existing upper ball joints or if they are a different taper? I'm asking because the ball joints don't appear to be pulling thru the spindle enough and I cant get the nut drawn up enough to put a cotter key thru it.
Matt49
05-26-2012, 06:15 PM
We just put the new s7 spindles on our smackdown car and I was wondering if they use the existing upper ball joints or if they are a different taper? I'm asking because the ball joints don't appear to be pulling thru the spindle enough and I cant get the nut drawn up enough to put a cotter key thru it.
Should be the same unless you got one that wasn't drilled right. We did get one once that had a drop of weld splatter down in the taper. Filed it out and it was good to go.
HuckleberryB4
06-04-2012, 10:21 PM
Thank you.
Powered by vBulletin® Version 4.2.0 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.