PDA

View Full Version : j bar help



0007
05-28-2012, 08:06 PM
does the j bar need to run strait mine is not sitting in the car square and wondering if it could be binding

washeduptoo
05-28-2012, 10:16 PM
If your talking about the frame end being ahead of the pinion end, yes, usually frame end is forward of pinion end.

0007
06-09-2012, 08:35 AM
my pinion end is ahead of the frame end

washeduptoo
06-09-2012, 09:40 AM
You might want to check the 72 inches from motor plate to center line of axle tube. I think that is the correct measurement. Good luck.

1Blacksheep
06-09-2012, 10:33 AM
4 bar left and its ahead at the pinion can develop a bind and interference with other components.

0007
06-09-2012, 10:42 AM
solid 3 link sportmod rearend is back far enough but it has spacers on each end where it bolts to pinion bracket and chassis bracket

1Blacksheep
06-09-2012, 10:51 AM
If it was mine I would run it as close to parallel with the axle as possible on 3 link.

0007
06-09-2012, 11:04 AM
ok thank you