dfhotlm33c
09-03-2012, 01:33 PM
My chassis has two LRL holes, about 2" difference on center..
they are directly in line vertically..no radius to them whatsoever..
This makes it virtually impossible to move the bar from the upper to lower hole without changing the rod length by turning the heims in...(I jack left side all the way up at frame until rear is at full drop..remove bar, and try jacking rear end until heim lines up...just doesn't happen)
are these two holes in line for a reason? To index spring even further when moving from upper to lower hole? should I make the rod the right length to fit in both holes?
Help! Thanks
they are directly in line vertically..no radius to them whatsoever..
This makes it virtually impossible to move the bar from the upper to lower hole without changing the rod length by turning the heims in...(I jack left side all the way up at frame until rear is at full drop..remove bar, and try jacking rear end until heim lines up...just doesn't happen)
are these two holes in line for a reason? To index spring even further when moving from upper to lower hole? should I make the rod the right length to fit in both holes?
Help! Thanks