View Full Version : Pull Bare vs. progressive rate spring
Dirt Knife
09-21-2012, 10:04 AM
Have an 08 Dirt works pull bar is at 25* down
Car loads and unloads down the straight
I get 3" on the spring 800lb
Do I decrease the angle or go try a progressive spring 600-1200lb???
Thanks
xxxmod
09-21-2012, 10:40 AM
Lower on the housing with a straight 1200lb
Dirt Knife
09-21-2012, 11:07 AM
Thanks for the info
Going from an 800 to a 1200 though
seems like a big step
Will give it a go though.
MasterSbilt_Racer
09-21-2012, 01:32 PM
Thanks for the info
Going from an 800 to a 1200 though
seems like a big step
Will give it a go though.
Dropping it on the housing makes it act softer.
Dirt Knife
09-21-2012, 01:44 PM
that helps me understand the move.
bob75
09-23-2012, 07:47 AM
if your getting 3 in travel , to much , not enough spring , get a shaw 700-2100 progressive . thats my opinion.ive done it it works
Powered by vBulletin® Version 4.2.0 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.