Headers

[Dirt racer 10]

Best all around set of headers (non-stepped) for a 602 crate? Running a 4 barrel carb. Which tubing size is better? Is there a difference between a schoenfeld 1185 and the schoenfeld 1185cm?

[brad hibbard]

What size track? and where are you looking for more power?

the cm is for a raised ex port and is not what you want on a 602 >>>>>>a 602 has a stock port location and does not use the cm suffix

the questions above pertain to primary tube size

basic header 101-------top end power big tube<<<vs>>>low end power little tube

before i start a debate---Yes there is a ton more to headers than that but start simple and build on that

Brad
www.race-1.com

[Dirt racer 10]

Thank you. These are the kind of generalizations that will help me learn. I'm not after specifics. It's a 3/8 mile track. What are the generalizations about tube length?

[brad hibbard]

a 3/8 mile track is usually in the small "stop and go" category

for that we recommend small tube and long collector--------------

however........... if this is a dirt track application and the track tends to go slick-----then an increase in tube size can add drivability to your program

Brad
www.race-1.com

[lindsey97]

Schonfield makes a specifically designed header for crate motors. It's a long tube header with a 12in collector. What I run on mine. Just call and talk to them.