View Full Version : Best %'s for Dry Slick track
3dinter
10-22-2012, 11:12 AM
What would you say "in your opinion" is the best weight percents for a dry slick track in a 3000 lb hobby, pure / factory stock on a 1/4 mile, semi banked track ?
Rear % =
Left % =
Cross % =
checkersorwreckers
10-23-2012, 07:58 PM
Depends on springs, shocks, weight placement; and most importantly driver feel and preference.
3dinter
10-25-2012, 09:16 AM
What only 1 answer...you guys must be pissed off racing season is over and are out deer hunting...bahabahbahbahabahaaaa
buterbaughb1
10-25-2012, 01:43 PM
The general rule we tend to follow is 52% Left, 52% Rear, and keep the cross under 55%.
Driver88
10-25-2012, 05:25 PM
There's not a right answer for your question.
billy5
10-25-2012, 06:14 PM
50.5 leftside---50 cross---58 rear.....even springs on the rear...super soft on rf..and extra heavy spring on lf for weight transfer.....outside tire pressures need to be 16-22 psi...lf 16psi--lr 8 psi so it can mash down smaller when load is applied....use same size tires on rear because even with low lr air pressure,,,when/if you spin them comming out then they will swell to the same o.d. pushing the car straight..
a1driver
10-25-2012, 07:16 PM
50.5 leftside---50 cross---58 rear.....even springs on the rear...super soft on rf..and extra heavy spring on lf for weight transfer.....outside tire pressures need to be 16-22 psi...lf 16psi--lr 8 psi so it can mash down smaller when load is applied....use same size tires on rear because even with low lr air pressure,,,when/if you spin them comming out then they will swell to the same o.d. pushing the car straight..
oooooooooooook. lol
billy5
10-26-2012, 08:11 AM
oooooooooooook. lol
if you have something better...offer him advice..
Powered by vBulletin® Version 4.2.0 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.