Mod77L
05-20-2013, 05:17 PM
What is everyone's opinion on how to set the M/C's on a set of pedals? I have a 1" rear and a 7/8" front. I think I'm supposed to have them the other way around. Is that right? Should be plunger screws be screwed into the clevises evenly? I finally had a good car last weekend and ending up spinning mid-corner, on the brakes (car in front checked up to hold his line). I always had them set so I got a lot more rear because I couldn't get the car to turn. Now it does, and I need to even out the bias a bit more. What is the "proper" way to set them? This is on a small "1/4" mile, if that matters.
Edit: I think I found what I need in a search. Sorry for the post.
Edit: I think I found what I need in a search. Sorry for the post.