PDA

View Full Version : Winters Quickchange Help


lilsumo
08-07-2013, 08:47 PM
I had a leak on the front of my quick change. I removed the drive yoke and the seal plate to find that the seal plate was trashed. The inner ring that is machine for the o-ring was gone and letting it pour out fluid. I purchased a new seal ring and installed it this evening. After getting it all back together it would not turn over.

The washer (it looks like its just a dust cover) that goes between the yoke and seal is locking it down. If I losen up the drive yoke bolt it will turn over, but if I tightened it down it locks up. I took the washer out and tightened it up and its free.
racin6mod
08-09-2013, 06:08 PM
not sure I understand you 100 percent but the tin plate goes in first then the aluminum seal plate and the yoke last. the tin plate is a splash guard to help keep most of the oil from the seal.
crowdpleazer
09-20-2013, 01:50 PM
I had a leak on the front of my quick change. I removed the drive yoke and the seal plate to find that the seal plate was trashed. The inner ring that is machine for the o-ring was gone and letting it pour out fluid. I purchased a new seal ring and installed it this evening. After getting it all back together it would not turn over.

The washer (it looks like its just a dust cover) that goes between the yoke and seal is locking it down. If I losen up the drive yoke bolt it will turn over, but if I tightened it down it locks up. I took the washer out and tightened it up and its free.

I had same problem.New yoke had different dust cover causing interference w pinion bracket.also saw a question on here that refrenced long vs.short yoke.i am running w/out dust cover...