rc14
08-25-2013, 10:03 AM
This listing is for a 2006 Lightning Modified Roller. Chassis #06-14 is a metric clip under rail chassis with a 1-1/2 cage.
The front suspension has Lightning Nova lowers & Lightning uppers with Pinto spindles & US Brake 5x5 front rotors. The ball joints and chrome moly heims were all new this Spring.
The rear suspension is currently setup 4bar / 4bar with j-bar, but can be setup z-link on either or both sides. It has a Lightning Rubber bisquit pullbar assembly.
The rearend is a 60 centered Winters Quickchange with 4.86 R&P. It is an aluminum center section with steel tubes, 31 spline axles, and Ace 5x5 hubs. It has a remote fill can for the rearend.
Includes an Afco 21 double pass aluminum radiator, SBC Mid Motor plate, MSD 6AL, & a 32 Fastshaft Driveshaft w/o yoke.
The interior has a window net, 15 aluminum steering wheel w/splined quick release, a Pro-lite 2-1 steering quickener, Wilwood reverse mount brake / clutch pedal assembly with (2) U.S. Brake 7/8 brake master cylinders & a 3/4 Wilwood clutch master cylinder, and an Afco brake bias adjuster.
It has a Kirkey Lightweight aluminum seat. There is no safety harness installed.
The Gauge panel features Quickcar Fuel Pressure, Oil Pressure, Water Temp & Volt gauges, A Quickcar Ignition Control Panel, Master Power Switch, & a VDO 0-9000rpm Tach.
The fuel cell has a 32 gallon capacity. Also includes AN-10 fuel line with fuel filter installed.
Includes (4) Fast Company/Afco rebuildable shocks. The rear shocks include coilover kits.
Includes (4) 2 offset wheels and used tires to roll on.
Please Note: Does not include the pictured Bert Ballspline or bellhousing.
Im asking $3950 or B.O.
This Racecar is Race Ready - Just add your Motor / Trans & Bellhousing / Safety harness!
Racecar is located approximately 25 miles east of downtown Cincinnati, Ohio off I-275 & St Rt 32.
Pictures can be seen by clicking on this link to Racing Junk ad: https://www.racingjunk.com/UMP-IMCA-Modifieds/181951010/2006-Lightning-Modified-Roller-3950-obo.html
If you need other specific pictures of chassis, let me know.
Contact Rick at (513)403-4114(if no answer, please leave a message) or email to rc14@cinci.rr.com
The front suspension has Lightning Nova lowers & Lightning uppers with Pinto spindles & US Brake 5x5 front rotors. The ball joints and chrome moly heims were all new this Spring.
The rear suspension is currently setup 4bar / 4bar with j-bar, but can be setup z-link on either or both sides. It has a Lightning Rubber bisquit pullbar assembly.
The rearend is a 60 centered Winters Quickchange with 4.86 R&P. It is an aluminum center section with steel tubes, 31 spline axles, and Ace 5x5 hubs. It has a remote fill can for the rearend.
Includes an Afco 21 double pass aluminum radiator, SBC Mid Motor plate, MSD 6AL, & a 32 Fastshaft Driveshaft w/o yoke.
The interior has a window net, 15 aluminum steering wheel w/splined quick release, a Pro-lite 2-1 steering quickener, Wilwood reverse mount brake / clutch pedal assembly with (2) U.S. Brake 7/8 brake master cylinders & a 3/4 Wilwood clutch master cylinder, and an Afco brake bias adjuster.
It has a Kirkey Lightweight aluminum seat. There is no safety harness installed.
The Gauge panel features Quickcar Fuel Pressure, Oil Pressure, Water Temp & Volt gauges, A Quickcar Ignition Control Panel, Master Power Switch, & a VDO 0-9000rpm Tach.
The fuel cell has a 32 gallon capacity. Also includes AN-10 fuel line with fuel filter installed.
Includes (4) Fast Company/Afco rebuildable shocks. The rear shocks include coilover kits.
Includes (4) 2 offset wheels and used tires to roll on.
Please Note: Does not include the pictured Bert Ballspline or bellhousing.
Im asking $3950 or B.O.
This Racecar is Race Ready - Just add your Motor / Trans & Bellhousing / Safety harness!
Racecar is located approximately 25 miles east of downtown Cincinnati, Ohio off I-275 & St Rt 32.
Pictures can be seen by clicking on this link to Racing Junk ad: https://www.racingjunk.com/UMP-IMCA-Modifieds/181951010/2006-Lightning-Modified-Roller-3950-obo.html
If you need other specific pictures of chassis, let me know.
Contact Rick at (513)403-4114(if no answer, please leave a message) or email to rc14@cinci.rr.com