Mounting a md3 nose?

[th_racer]

How high are you guys mounting the nose off the ground? are you mounting them with the right side 2" higher than the left like their molded?

[kevpow]

Mine is 5" on the left and 9" on the right!

[MasterSbilt_Racer]

You need at least 11" on the rf, at splitter, IMO.

[th_racer]

Thanks guys, How much tilt are you running mastersbilt?

[7uptruckracer]

2" is built into the nose itself and run the valance for sure it makes life easier. You want to seal your nose 10-12 on the RF

[MasterSbilt_Racer]

Thanks guys, How much tilt are you running mastersbilt?

I think 5".

[7uptruckracer]

Is that 5" with your valance trimmed or newly installed before trimming?

[MasterSbilt_Racer]

Is that 5" with your valance trimmed or newly installed before trimming?

Trimmed. There is basically no valence on the right side.

[mopar92]

10-11" at ride height ready to race? seems high...

[TheJet-09]

10-11" isn't too much if you get over on the RF, and especially if you run on any rough tracks like we have up north.

[MasterSbilt_Racer]

10-11" at ride height ready to race? seems high...

If you are really getting down on the rf, you will want to be at the same height as the center of the hub.

[mopar92]

Good references. Thanks.

[RacerX10]

Anybody else hate the way those jacked up nose pieces look now ?