timcole421
11-16-2013, 09:09 PM
Hi!
I am currently running a muncie style trans (21" length) with a 4" yoke. About one inch is visible between the end of the tailshaft and the end of the yoke. I am going to bert transmissions (non-ballspline) which are three inches longer. Would it be OK to use the same driveshafts, but go to an 8" yoke? This would have about 4" inside the tail, and 4" outside the tail. Any possible balance issues or any other problems?
Thanks in advance.....
I am currently running a muncie style trans (21" length) with a 4" yoke. About one inch is visible between the end of the tailshaft and the end of the yoke. I am going to bert transmissions (non-ballspline) which are three inches longer. Would it be OK to use the same driveshafts, but go to an 8" yoke? This would have about 4" inside the tail, and 4" outside the tail. Any possible balance issues or any other problems?
Thanks in advance.....