PDA

View Full Version : break in rockers


DANNY
12-19-2013, 09:58 AM
Looking for some break in rockers. I really don't want to pull heads apart to only run outer spring to break in a flat tappet cam.

Pre owned that is :)
stock car driver
12-19-2013, 10:26 AM
What are they worth? I have Harland sharps in 3/8 and 7/16 stud.
CNC BLOCKS
12-19-2013, 11:22 AM
What engine Ford or Chevy I have both 1.2 and 1.35 for chevy 7/16 studs and in most cases the heads may have to be machined as the push rod is pushed away from the stud which some times causes clearance issues.
stock car driver
12-19-2013, 11:32 AM
Good point on the head clearance. Ive had some motors (oem or eom replacement eq junk) that the pushrod rubbed on the back of the slot or drilled out hole, I used them anyways and figured the rub wasn't enough to increase the pressure at the lifter by much.
DANNY
12-19-2013, 01:08 PM
It's for Chevy pro topline head, 7/16 stud.
DANNY
12-20-2013, 12:11 PM
If u want to sell shoot me an Email...

Pepe1352@hotmail.com
DANNY
01-04-2014, 02:02 PM
Still lookin, figure I try one more time if anyone has any they want to sell before I get new ones...