View Full Version : rocker arm stud.
tn_dude05
01-27-2014, 05:25 AM
I have an older pair of double hump heads, I need to remove the pressed in studs and use a screw in stud. My question is, do I need to have the stud bosses cut down or just tap the bosses the way that they are after removing the pressed in stud's?
perfconn
01-27-2014, 10:09 AM
Depends on whether the screw in studs have a hex on them.If there is a hex then you must remove the thickness of the hex from the stud boss.If no hex then just tap them and install studs.
ford396
01-27-2014, 05:50 PM
If you are going to run guide plates, you may want to also add their thickness to the amount milled off the top of the bosses.
Bob
Powered by vBulletin® Version 4.2.0 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.