View Full Version : Crossmember
Rocket new raised crosmember does it use the same rack?
Brian Gray
02-16-2014, 01:37 PM
Clevis type is needed
Thanks , can you change the ends on your excisting rack?
Matt49
02-16-2014, 06:54 PM
Thanks , can you change the ends on your excisting rack?
Yes you can. Not terribly difficult. Pull back the rubber boot and there's a set screw. Once the set screw is out the entire end threads off of the rack.
rocket1*
02-16-2014, 08:05 PM
The slotted ends also make setting the bump steer much easier.
toloud
02-22-2014, 08:02 PM
Rocket new raised crosmember does it use the same rack?
Yes you can use the same rack with the same ends. I did not measure the spacer between the rack and frame but it looked 1/8. RF needs the small spacer that comes with a sweet rack at the rack nothing at the spindle. LF needs 200 thousandths at the rack and I think 1/2 at the spindle.
If it is different i will correct as soon as have time to get to te shop.
Powered by vBulletin® Version 4.2.0 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.