EQ Cylinder Head Issues

[racing_rookie13]

Im having trouble with a set of eq heads for a 350, its on a wissota car but they are the imca approved heads. when installed the pushrod doesnt line up with the rocker arm correctly? it has caused 3 lifters to come apart due to the angle of the rods, it also pushes the rocker arms off to one side of the valves, and changes my valve lash settings. anybody have issues with this? thinking these heads were a mistake.

[JustAddDirt]

might need and offset lifter, or rocker arm?

[racing_rookie13]

stock car, this is what i was thinking of doing, not a problem to machine out the holes, will look at guide plates, the offset lifters or rockers would not be legal

[racing_rookie13]

Ok when you say real big any idea how big is needed? Same size as the length of the slot? I saw the comp guides, will get a set ordered, this will be a backuo motor for now, trying to get it all straight before I install it, thanks for your help! also did you have to machine off under rockers to offset the thickness of the plates? or use longer pushrods? or could you still adjust them in properly?

[racing_rookie13]

Ok thats what I figured, thanks for your advice!