dirtdodger
06-30-2014, 07:03 AM
have a 2010 rayburn combo car setting up as a crate with a 602, i have an msd 7al ignition. need to know few things:
what size battery 12v/16v?
what size radiator are being used? single double pass?
what type of coil and distributor?
gonna get a 650 carb what type/ size of spacer? 2" max for 602.
what length drive shaft with bert tranny? also yokes?
what type fuel pump? do i need to run a pressure regulator?
water pump, standard small block? long or short?
what size, type pulleys? do i need any shims or anything? what belts?
what fan blade and spacer?
do i need to raise engine up an inch or so? if so what kind of front mount?
do i need a power steering pump? if so what type? have appleton rack.
what kind of spark plugs? good set of wires?
oil cooler? if so good one at decent price?
what type of bolts should be used to mount engine to rear and front plate? fuel pump? water pump? do i need a stud kit for carb and spacer?
do i need an altenator?
is there a kit i can get for the front of the motor for a resonable price?
basically i have rolling chassis and 602 motor with no bolt ons, need to know what to get me on track. most of my experience is with supers have 6-8 years experience workin on and setting up cars that i can pretty much handle, if i had everything with it could throw it together in couple hours, this is my first car on my own and don't have bolt ons or bolts to bolt them on on the motor itself and have never worked with a crate engine. any help would be extremely appreciated and thanks in advance. if i think of any other things will post some more coments to this tread.
what size battery 12v/16v?
what size radiator are being used? single double pass?
what type of coil and distributor?
gonna get a 650 carb what type/ size of spacer? 2" max for 602.
what length drive shaft with bert tranny? also yokes?
what type fuel pump? do i need to run a pressure regulator?
water pump, standard small block? long or short?
what size, type pulleys? do i need any shims or anything? what belts?
what fan blade and spacer?
do i need to raise engine up an inch or so? if so what kind of front mount?
do i need a power steering pump? if so what type? have appleton rack.
what kind of spark plugs? good set of wires?
oil cooler? if so good one at decent price?
what type of bolts should be used to mount engine to rear and front plate? fuel pump? water pump? do i need a stud kit for carb and spacer?
do i need an altenator?
is there a kit i can get for the front of the motor for a resonable price?
basically i have rolling chassis and 602 motor with no bolt ons, need to know what to get me on track. most of my experience is with supers have 6-8 years experience workin on and setting up cars that i can pretty much handle, if i had everything with it could throw it together in couple hours, this is my first car on my own and don't have bolt ons or bolts to bolt them on on the motor itself and have never worked with a crate engine. any help would be extremely appreciated and thanks in advance. if i think of any other things will post some more coments to this tread.