View Full Version : loose corner entry
Nester Racing
08-07-2014, 10:44 AM
My car is loose on corner entry in the feature but good in heat race ! How should I tighten the car I have 250 175 in the rear should I go up in rate or down on right rear
StreetStock57H
08-07-2014, 02:31 PM
what wheel offsets you running?
Nester Racing
08-07-2014, 03:06 PM
2" on left and 3" on right can fit a 4" on right
Driver50x
08-07-2014, 04:00 PM
What are your weight percentages and your bite?
Nester Racing
08-07-2014, 04:51 PM
That's with driver and front springs are 1000 1100
Racer96m
08-08-2014, 01:21 AM
Put 2" offsets up front, 3" on LR and a 4" on RR and take the stagger out of it should help.
Dave
Nester Racing
08-09-2014, 03:14 PM
Thanks I'll give it a try!
drtrkr244
08-09-2014, 03:56 PM
That's pretty soft of a RR spring if the car is 2800plus pounds. I would put a 225 or 250 in and/or swap front springs.
Nester Racing
08-09-2014, 07:50 PM
That's pretty soft of a RR spring if the car is 2800plus pounds. I would put a 225 or 250 in and/or swap front springs.
So If I put a 225 in the right what should I try in the left 275-300 ?
drtrkr244
08-09-2014, 10:13 PM
Stay with 250 unless you lose some forward bite, then go up to 275/300....good luck
StreetStock57H
08-14-2014, 11:25 AM
could also try dropping left side % some and increasing rear % a little bit. or try flip flopping the front springs.
Powered by vBulletin® Version 4.2.0 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.