propit21
09-08-2014, 07:15 PM
Rule.
Must use one upper control arm, solid tube only, located at top center of rear end housing and remain centered (one inch tolerance) on housing over drive shaft
Does the chassis mount have to be over the drive shaft or can you mount that left or right of drive shaft?
Next question is there a difference on the LR to mount the shock in front or back of the rear end housing, what would be the reason for running either way.
If you move the rearend housing to the left 1 inch what would need to be check as far as binds, clearance issues, and would it messed anything up? Would doing this crate any undesirable conditions?
Must use one upper control arm, solid tube only, located at top center of rear end housing and remain centered (one inch tolerance) on housing over drive shaft
Does the chassis mount have to be over the drive shaft or can you mount that left or right of drive shaft?
Next question is there a difference on the LR to mount the shock in front or back of the rear end housing, what would be the reason for running either way.
If you move the rearend housing to the left 1 inch what would need to be check as far as binds, clearance issues, and would it messed anything up? Would doing this crate any undesirable conditions?