Pierce Help

[Derekc11s]

What is a good starting angle for the short straight bar (panhard bar)? I will be racing small 1/4 mile tracks. Any info will help,Thanks.

[langdonracing48]

Can't remember for sure, but I believe pierce calls for 3" of rake in the shorty bar.

[langdonracing48]

Give Scott Reynolds a call at 269-729-4804. He's good with pierce stuff.

[bob75]

It depends on your car if you use pierces framer bracket use center hole with the bracket all the way up,2 nd hole from the top on the rear end total length if a quick change will between 14. 1/2 to 15 in 815. 541. 9656 if any questions

[Mosidebite]

9" up from bottom of round tube to center of bolt is where you want to start on frame side. Then go with recommended points from set up book for pinion. He doesn't like a angle change much, "changes too many other things".

[illiniracer]

they have a tech line--very helpful 217-354-2972