three link need drive off

[lapsetter3]

i know this is a mod page but need help with a three link pro stock. 3200 lb car 55%left 55%rear 49.5 cross 68 lbs lr bite. springs 1000lf 1100rf 225lr 175rr. shocks lf5-3 rf3-5 lr8-2 rr3-5. upper link solid@18* both lowers @ 5*. j bar not sure of rake though. lacking drive off any help appreciated dont think theres that many guys on the stock page running three links.

[Fox_hunter42]

your upper link if this is bar from top of rear end to frame then that is prob the problem. Go to a progressive spring link, mount lr spring in front of axle and shock behind, rr spring behind shock in front. on j bar use first hole below center of pinion, pass side, and around 7 degrees up to frame. on dr's side. My opinion your car is a little heavy on the left, and a little light on bite. I like 52% l and 100# bite

[lapsetter3]

Thanks for the input but top link must be solid and springs must be in stock location on top of rear

[lapsetter3]

I will check the jbar though think it has more rake than that I will move it down a hole or two on the frame

[Fox_hunter42]

that will be tuff with a solid 3rd link.

[langdonracing48]

Move th pull bar as far to the left side as you can, run more bite as well. On a tacky track I always ran 120# with a solid pull bar, on slick I was up in the 220 to 250 range depending on how slick it was.

[lapsetter3]

Move th pull bar as far to the left side as you can, run more bite as well. On a tacky track I always ran 120# with a solid pull bar, on slick I was up in the 220 to 250 range depending on how slick it was.Thanks for the help. I'll try that