View Full Version : Bert shifter question
swrracing99
12-01-2015, 10:38 PM
I have recently purchased a bwrc. The shifter linkages have a quick disconnect on 1 end with a hiem joint on the other. I'm trying to find the male end of the disconnect that will thread into a Bert shift leaver on the trans. Any help would be greatly appreciated.
TALON75
12-01-2015, 11:44 PM
Is it like this?
http://www.krcracing.com/Graphics/quickdetach.htm
swrracing99
12-02-2015, 02:31 PM
Yes. But larger. The ball looks like it should be abound 3/8 or so in diameter.
TALON75
12-02-2015, 09:15 PM
http://www.qa1.net/rod-ends-and-related/ball-joint-linkages/quick-connect-disconnect-ball-joints
Maybe this?
latemodel86
12-02-2015, 11:08 PM
http://www.qa1.net/rod-ends-and-related/ball-joint-linkages/quick-connect-disconnect-ball-joints
Maybe this?
I think you could get those at the local auto parts store. Looks real similar to a tractor ball joint.
swrracing99
12-03-2015, 09:11 AM
No. I found them at BWRC. Thanks for the help
swrracing99
12-03-2015, 09:13 AM
No. I found them at BWRC. Thanks for the help. After looking talon75 yes that's what it looks like.
Powered by vBulletin® Version 4.2.0 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.