Bert Gen 2 oil blow by?

[Burke1118]

Just recently I started noticing a bunch of oil around the transmission after runs and idling in the shop today, it pushed a decent amount of oil out of the over flow tube on to the shop floor. Any ideas? Hasn’t done this before and it’s relatively fresh. Thanks

[JustAddDirt]

how much fluid are you using to fill?
IIRC it is like 3/4 of a quart.
also do you have the vent tube running vertical, then a loop at the top and running back down?

[Burke1118]

how much fluid are you using to fill?IIRC it is like 3/4 of a quart.also do you have the vent tube running vertical, then a loop at the top and running back down?I have a loop, and it filled to the bottom sight glass

[Burke1118]

how much fluid are you using to fill?IIRC it is like 3/4 of a quart.also do you have the vent tube running vertical, then a loop at the top and running back down?I have a loop, and it filled to the bottom sight glass

[JustAddDirt]

needs to be 1/2" below fill plug or site glass.
believe you have to much fluid in it.

[CCHIEF]

needs to be 1/2" below fill plug or site glass. believe you have to much fluid in it. VERY probable and likely This^^