|
|
-
Older Activity
-
02-22-2024, 01:13 PM
Replied to PM
20 replies | 5632 view(s)
-
02-21-2024, 05:36 PM
I have another way that should work way better and be really hard for tech to see or figure it out, but don't want to post here for everyone to see....
20 replies | 5632 view(s)
-
02-21-2024, 04:12 PM
Try this so a restrictor doesn't keep the brake on
Red is the restrictor and blue is a one way valve to release pressure around the...
20 replies | 5632 view(s)
-
02-15-2024, 04:04 PM
So your saying after spending 850K on a new hauler, I need to spend more and get a 100 Ton AC unit and a 1,000,000 BTU heater for the trailer to...
59 replies | 22562 view(s)
-
02-07-2024, 12:23 AM
A friend at one of the big companies saw this post and reached out to me thru a text since he isn't registered here.
Here is what he had to say:...
9 replies | 2107 view(s)
-
01-25-2024, 06:13 PM
You won't see a power lose being to small on gap but will for sure if too big.
It hurts nothing to start small and see if it helps your issue. I...
30 replies | 6810 view(s)
-
01-25-2024, 11:44 AM
Yes, for the most part. It does vary on what brand of motor your talking about or what style of motor.
Last I knew a new chevy from Clemens is 55K
59 replies | 20107 view(s)
-
01-23-2024, 04:17 PM
A shock that was deemed illegal years and years ago, but bilstein made the shock where basically it had a cover on the top of it so the shaft didn't...
59 replies | 20107 view(s)
-
01-23-2024, 04:00 PM
This may go along the lines to back up some of lizardracings info:
The improvement I think we saw on both motors (wasn't scientific by any means)...
30 replies | 6810 view(s)
-
01-22-2024, 08:12 PM
Not sure what your running for plug gap, but you can kill 50HP and a ton of RPM out of a motor with too large for your ignition and never hear it on...
30 replies | 6810 view(s)
-
01-22-2024, 08:05 PM
While it's not E85 but on gas engines.
One a smaller spec type engine (700HP) Builder said 8800 but in the car it seems to stop at 8200/8300. Did...
30 replies | 6810 view(s)
-
01-22-2024, 08:37 AM
Can't say I've experienced that with e85 but haven't ran E85 on a lot of dirt track stuff besides a crate which doesn't get to those RPM's.
I'm...
30 replies | 6810 view(s)
-
01-18-2024, 02:50 PM
I'm gonna go out on a limb and take some educated guesses here, so. . .
I would say most of the people that would have one, wouldn't run a tire...
11 replies | 3078 view(s)
-
01-17-2024, 09:18 PM
Some of how much use you would get out of something like that is:
1. If the spring rate is way off what you normally get with the tires you run,...
11 replies | 3078 view(s)
-
01-16-2024, 01:05 PM
Surely with front stagger, since the LF is turning faster then the RF: The car will drive right, correct? (sarcasm)
14 replies | 5296 view(s)
-
01-16-2024, 01:02 PM
Agreed. On a side note, with higher pressures make sure your hose connections have a good bulge or ridge on the component or you can blow a hose off.
5 replies | 1842 view(s)
-
01-15-2024, 07:16 AM
When it was built, it was the largest Dirt LM engine that Cornette had ever built, is that still the case? not sure. It's a couple years old now, if...
35 replies | 13974 view(s)
-
12-27-2023, 11:59 AM
aluminum or carbon fiber sheet
3 replies | 1329 view(s)
-
12-13-2023, 10:59 PM
Sometimes you are using them for a reason, like using a softer spring but making it stiffer to the rate you want at a certain compressed measurement...
8 replies | 3882 view(s)
-
12-13-2023, 10:56 PM
Example 300# spring 1" is 300# 2" is 600# and 3" is 900#
could always go to a 325# spring: So 1" is 325# and 2" is 650# and 3" is 975#
Taking...
8 replies | 3882 view(s)
-
12-13-2023, 01:51 AM
A spring rubber basically makes a spring progressive. It progressively deactivates one coil of the spring so the rate of the spring increases the...
8 replies | 3882 view(s)
-
12-06-2023, 12:54 PM
It depends on what kind of heat your seeing out of rotors by how hard you are using them. That being said:
If your a crate or limited and not...
2 replies | 1345 view(s)
-
11-08-2023, 12:58 PM
For sure, I'm being very generous with how little it could cost to run a tour. Did I just say how little super engines can cost, LOL
35 replies | 7910 view(s)
-
11-08-2023, 12:55 PM
Also keep in mind that just the engine builders bill on engines. Lets say guys run 400 laps on oil so only 3 oil changes per engine before...
35 replies | 7910 view(s)
-
11-08-2023, 12:44 PM
Every team is gonna be different on how many complete spare cars they have and extra engines. Take lucas oil for example: their lap count varies a...
35 replies | 7910 view(s)
-
11-06-2023, 06:38 PM
A new Clemens is 55K and a freshen after 1200 laps with no breakage is 15k'ish
2 years ago a Clemens was 46K (late 2021), freshening likely may...
35 replies | 7910 view(s)
-
10-27-2023, 03:16 PM
Worked fine with GPS receiver on roof for telemetry system, but when I tried using the GPS receiver below the deck (like not having telemetry on car)...
6 replies | 1813 view(s)
-
10-26-2023, 06:42 PM
I tried but kept losing GSP signal and messing with the car. Still have to sort that out
6 replies | 1813 view(s)
-
10-26-2023, 06:12 PM
You mean one like this?
6 replies | 1813 view(s)
-
10-18-2023, 09:24 PM
Many newer dry sump tanks have a smaller #8 or #10 fitting in them to hook up the primer too.
10 replies | 2232 view(s)
About billetbirdcage
- Biography:
- Taylormade Proformance
- Location:
- Kansas
- Interests:
- Racing
- Occupation:
- Manufacturer of LM parts
Total Posts
- Total Posts
- 1,935
- Posts Per Day
- 0.31
Visitor Messages
- Total Messages
- 1
- Most Recent Message
- 11-10-2015 03:40 PM
General Information
- Last Activity
- 03-26-2024 01:40 PM
- Join Date
- 05-15-2007
- Referrals
- 0
All times are GMT -5. The time now is 03:44 AM.
|
|