|
|
-
Older Activity
-
06-23-2022, 06:02 PM
During a flo streamed race, they had 20K people/accounts watching. Not signed up but actually watching that one race.
39 replies | 3584 view(s)
-
06-22-2022, 01:57 AM
Before the frames got stiffer in the last 5 to 6 years, 2 cars identical but one being 2" square vs 1.75 or even 2" round: The square tube cars seem...
9 replies | 515 view(s)
-
06-22-2022, 01:53 AM
Load (or if you want to look it at as travel) doesn't know if it's a single spring, stack, bump, or an air bag for that matter.
If you lessen the...
13 replies | 2091 view(s)
-
06-22-2022, 01:49 AM
Assuming your keeping the pinion in the same place so basically moving each wheel inboard 1"?
9 replies | 371 view(s)
-
06-20-2022, 03:14 PM
You treat it as exit (think I remember your in a crate), so you reduce the load to make the RF travel father and dewedge the car to loosen it...
13 replies | 2091 view(s)
-
06-17-2022, 02:21 PM
What gear was they pulling, lol
A 4.11 gear at 8285 RPM is required to hit 174 MPH
18 replies | 455 view(s)
-
06-17-2022, 02:15 PM
#Note I never looked at race monitor as someone said they weren't showing laps times so I never bothered to look, well they are showing them now.
...
18 replies | 455 view(s)
-
06-16-2022, 01:58 PM
2008:
Time Trial Results (Position/No./Driver/Hometown/Best Lap):
1. 44-Earl Pearson Jr./Jacksonville, FL 16.187 (111.200)
2. 07-Kelly...
18 replies | 455 view(s)
-
06-16-2022, 01:55 PM
2008 WoO show: Pearson’s blazing lap of 16.187 seconds in time trials precisely matched the one-lap standard established by Billy Moyer of...
18 replies | 455 view(s)
-
06-16-2022, 01:52 PM
OK, hard to find dates and times but I found this
The Stacker 2® Xtreme DirtCar Series was 2004 (we where there and raced and recall lap times)...
18 replies | 455 view(s)
-
06-16-2022, 01:33 PM
I also know guys where running about the same gear we ran back in the day, but we didn't turn as much RPM with the big motors as they do now. Typical...
18 replies | 455 view(s)
-
06-16-2022, 01:28 PM
At the extreme race the race track was extremely wet and I mean wet. We had like 40 cars there from what I remember and think we ran a support class...
18 replies | 455 view(s)
-
06-16-2022, 01:24 PM
JD ran a 16.00 in hot laps, 16.3 in qualifying and a 15.9 in the heat, this weekend.
Watch his in car camera in the feature, when jason told him...
18 replies | 455 view(s)
-
06-16-2022, 01:21 PM
Maybe I don't remember the times but I swear Moyer at the extreme race there ran a 17.1 not a 16.1. I remember this because when we ran there with...
18 replies | 455 view(s)
-
06-14-2022, 04:00 PM
Sometimes it took up to 2 hours to get a text to send, worse when the storms where brewing up. Other times it took 1 to 10 mins for them to send....
21 replies | 1786 view(s)
-
06-14-2022, 03:57 PM
Also they cut the laps to 20 and also informed us that we would run no more then 10 straight green flag laps, if we did they would throw a...
44 replies | 5859 view(s)
-
06-14-2022, 03:55 PM
They have killed any opportunity to ever have LM there on the high banks ever again. If the big names won't run on the big track, what chance of ever...
44 replies | 5859 view(s)
-
06-07-2022, 02:41 PM
They are removing the new dirt so. . . shrugs
61 replies | 3763 view(s)
-
06-07-2022, 02:40 PM
They removing the new dirt
183 replies | 23065 view(s)
-
05-30-2022, 04:43 PM
You can bet 100% some teams have or are building cars specifically for the million, I bet many are rushing to beef up parts as we speak as it's...
22 replies | 2360 view(s)
-
05-28-2022, 06:45 PM
Anyone else getting a failed certificate so browsers are blocking the ability to go to website? (on a PC) I bypassed the safety on the browser and it...
21 replies | 2189 view(s)
-
05-28-2022, 05:00 PM
I don't make it over there like I used to but been going over there before it was bought and turned into lucas oil speedway. A lot has changed about...
21 replies | 2189 view(s)
-
05-21-2022, 01:36 PM
Your supposed to have the belt guides on the upper pulley and is the easiest way to solve the problem
...
4 replies | 295 view(s)
-
05-16-2022, 05:43 PM
You can pick about anything that just ends up with something around 90# or less. I would go 85# or less so you see a change more easily and have a...
12 replies | 627 view(s)
-
05-16-2022, 05:40 PM
That's a loaded question, lol
Not knowing anything about the car, track and etc or what issues your having. I would alter the extended load 50#,...
12 replies | 627 view(s)
-
05-16-2022, 05:23 PM
However if you use an 8" lower you have no threads to put the lock nut because the floater is off the shock body. How far your shock is threaded down...
12 replies | 627 view(s)
-
05-16-2022, 05:22 PM
20" of total spring is about all you can typically use depending on your shock brand. More then that and your top nut will be all the way up and...
12 replies | 627 view(s)
-
05-16-2022, 05:12 PM
No idea on XR, but I know on one flo streamed race they had 20K watching that one race and it wasn't a crown jewel type race
21 replies | 3303 view(s)
-
05-16-2022, 04:48 PM
If I do the actual 175/200
23" 150#
Hits lock up to cut the load down
22" 271#
21" 364#
20" 457#
19" 550#
The stack is a little better...
12 replies | 627 view(s)
-
05-16-2022, 04:45 PM
Sorry, I could have said better
Yes it does, but it's the load you need to be looking at not the rate of spring persay.
Basically since those...
12 replies | 627 view(s)
About billetbirdcage
- Biography:
- Taylormade Proformance
- Location:
- Kansas
- Interests:
- Racing
- Occupation:
- Manufacturer of LM parts
Total Posts
- Total Posts
- 1,743
- Posts Per Day
- 0.32
Visitor Messages
- Total Messages
- 1
- Most Recent Message
- 11-10-2015 03:40 PM
General Information
- Last Activity
- 06-25-2022 01:04 PM
- Join Date
- 05-15-2007
- Referrals
- 0
All times are GMT -5. The time now is 09:28 AM.
|
|