|
|
-
Older Activity
-
09-28-2023, 12:42 AM
No, if you know what your doing and pretty much all teams do now. you can get 2"+ more deck by doing one simple thing but it will mess with your set...
4 replies | 1213 view(s)
-
09-26-2023, 09:22 PM
yes, it would change what your car measured
4 replies | 1213 view(s)
-
09-21-2023, 06:31 PM
They are doing it for a suspension/loading reason, it's just not fully aero
14 replies | 1821 view(s)
-
09-11-2023, 03:59 PM
Obviously it varies car to car or team to team but 1" to 2" over ride height is pretty typical with average being closer to the higher number.
...
18 replies | 1608 view(s)
-
09-11-2023, 12:56 PM
While true, many are also just running too close to hitting the frame on the ground. Catch one of the ruts or bumps at the wrong time or way, and the...
18 replies | 1608 view(s)
-
09-11-2023, 12:49 PM
Yes, they do^
18 replies | 1608 view(s)
-
09-08-2023, 02:42 PM
There is no crossover (or wasn't years ago) as those bearing are custom made and they are all import bearings. Being import bearings they aren't the...
2 replies | 297 view(s)
-
08-28-2023, 01:14 PM
Cranky, I was out of town for a while. I did answer your PM now.
2 replies | 1095 view(s)
-
08-24-2023, 12:22 AM
More forward with the upper bar will increase index over moving it back.
2 replies | 1095 view(s)
-
08-23-2023, 11:37 PM
You taking top or bottom seperately or moving both equally?
Forward both or just top will lift more on the front end of car (actually not 100%...
1 replies | 466 view(s)
-
08-23-2023, 04:06 PM
I keep an old dummy shock around and a spring of a known rate that isn't used anymore except on the dummy to check load at 1" increments to verify...
8 replies | 697 view(s)
-
08-22-2023, 06:58 PM
3's just like 30's needs lots of sipes. I prefer more sipes and less deep. To be honest you sort of treat it as a harder tire then a 40 as far as...
1 replies | 437 view(s)
-
08-08-2023, 11:27 AM
There's no way to really know what everyone is doing, but I would say yes guys are still moving lead around. I would say mostly for large changes in...
9 replies | 1687 view(s)
-
08-01-2023, 01:43 PM
They can't even enforce the body rules we had/have, how are they gonna measure a chassis?
30 replies | 2867 view(s)
-
07-30-2023, 02:59 PM
Josh Bayko: He hasn’t blown any motors
Not disagreeing with you, but he did blow a motor the first night at the show me and they changed motors...
62 replies | 6363 view(s)
-
07-18-2023, 04:11 PM
Cheating a transponder is completely possible as I know it has been tried at the highest level of asphalt racing but while semi easy to do, there is...
166 replies | 17531 view(s)
-
07-12-2023, 02:07 PM
100% that the new universal body rules and getting rid of the wedge cars, had a huge effect on car counts. Around 2014ish is when the cars started...
44 replies | 5163 view(s)
-
07-11-2023, 03:15 PM
The problem with answering that question is there is no way to really know if the axle was better. There is no doubt there entire car combination...
34 replies | 4736 view(s)
-
07-10-2023, 05:00 PM
Here is a question that should be asked?
Do all the chassis have the front of the frame where the bumper attaches (where they say the transponder...
166 replies | 17531 view(s)
-
07-10-2023, 04:52 PM
That's because the transponders where not in the same place on the car, one had the transponder mount farther back then was allowed and the other was...
166 replies | 17531 view(s)
-
07-09-2023, 05:59 PM
There are tons of things that aren't in the rules that they enforce and other things they enforce that are done in a different manner or measurement...
166 replies | 17531 view(s)
-
07-06-2023, 06:23 PM
Anythings possible but I give it a 99% chance that nothing changes on body rules
45 replies | 6171 view(s)
-
07-06-2023, 10:08 AM
You could buy all the axle, spindles, hubs and etc from behrents for less then what rocket lowers and upper arms and spindles cost. How do I know...
34 replies | 4736 view(s)
-
07-01-2023, 12:12 PM
Last time I checked a drivers license wasn't required to race a LM.
10 replies | 2747 view(s)
-
06-29-2023, 08:53 PM
Banning that username will not ban you. His is spelled with a lower case "L" instead of a capital "I" but it looks similar but spelling is different...
42 replies | 4705 view(s)
-
06-24-2023, 01:51 AM
Most all use a 5 stage and larger tanks, ours completely dry and new takes 26 quarts
9 replies | 1687 view(s)
-
06-22-2023, 07:32 AM
Frames are roughly 50# heavier then they used to be 10/15 years ago due to extra tubing in them to make the cars stiffer. Then add in the following:...
9 replies | 1687 view(s)
-
06-21-2023, 12:22 PM
That's the big track, the XR LM show is on the small track. You will never see LM's on the big track again after the last XR show on the big track.
8 replies | 1415 view(s)
-
06-21-2023, 12:19 PM
Cancelled due to rain
8 replies | 1415 view(s)
-
06-19-2023, 03:44 PM
I'll PM you an email addy and number to text too
10 replies | 980 view(s)
About billetbirdcage
- Biography:
- Taylormade Proformance
- Location:
- Kansas
- Interests:
- Racing
- Occupation:
- Manufacturer of LM parts
Total Posts
- Total Posts
- 1,899
- Posts Per Day
- 0.32
Visitor Messages
- Total Messages
- 1
- Most Recent Message
- 11-10-2015 03:40 PM
General Information
- Last Activity
- 09-29-2023 12:35 PM
- Join Date
- 05-15-2007
- Referrals
- 0
All times are GMT -5. The time now is 07:47 AM.
|
|
Find latest posts
09-28-2023, 12:42 AMNo, if you know what your doing and pretty much all teams do now. you can get 2"+ more deck by doing one simple thing but it will mess with your set...4 replies | 1213 view(s)