|
|
-
Older Activity
-
07-15-2022, 11:25 AM
Not sure. This one with water in it is a PowerMaster. I'd probably go the Toyota route next time I get one.
4 replies | 438 view(s)
-
07-14-2022, 04:02 PM
Hadn't thought of that. Are you just setting the jug up on the deck ? What kind of hose are you using ?
9 replies | 540 view(s)
-
07-14-2022, 04:01 PM
Interesting, and I think you're right ! Mine are square type.
9 replies | 540 view(s)
-
07-14-2022, 03:25 PM
Anybody figured out how to keep the 5 gallon fuel jugs from pissing / leaking fuel all over the place when filling up the car ? Have had this...
9 replies | 540 view(s)
-
07-13-2022, 10:26 AM
have a new power master starter, after first car wash I noticed the solenoid portion got full of water and I was careful not to spray any water...
4 replies | 438 view(s)
-
06-06-2022, 01:32 PM
That's a great idea. My shocks currently have the "standard" settings sticker on, but heavy / slick added would be nice.
10 replies | 1155 view(s)
-
05-31-2022, 11:01 PM
Yah .. was just offering up the 12 click info for "relative comparison" purposes.
My shock builder is "integra" :) I'm not at a level that...
10 replies | 1155 view(s)
-
05-30-2022, 09:46 PM
guess I should have mentioned, the Integra IDAs are 12 clicks end to end
10 replies | 1155 view(s)
-
05-30-2022, 11:12 AM
Does this shock tuning guide from Integra still apply in 2020 ?
Any thoughts appreciated.
10 replies | 1155 view(s)
-
05-25-2022, 05:56 AM
worse than that. battery wired backwards :)
2 replies | 587 view(s)
-
05-21-2022, 03:19 PM
I've never had a fresh air system on my car but this rocket that I bought has one in it.
however, when I fire it up it doesn't seem like it's...
2 replies | 587 view(s)
-
05-21-2022, 03:17 PM
awesome .. thank you !
4 replies | 399 view(s)
-
05-21-2022, 10:39 AM
Ok thanks for your idea, where did you get the shields for the top gear ?
I might also try shimming the top mounting bolt with thin metal to...
4 replies | 399 view(s)
-
05-21-2022, 01:40 AM
i've just switched from a full dry sump stack to a power steering and fuel pump only setup on my bert bellhousing. for some reason on the new pump,...
4 replies | 399 view(s)
-
02-24-2022, 05:22 PM
I guess that's kind of my point, after you get your front geometry set at the proper ride height, you can call your center to center anything you...
5 replies | 1395 view(s)
-
02-24-2022, 03:30 PM
So I was getting ready to cut up the car and put a 1" higher RF shock mount on the car, but had a shower thought .. do I really give a crap what the...
5 replies | 1395 view(s)
-
02-16-2022, 08:53 AM
Thanks !
I smashed the setup with the new C-C of 18.750 and the shorter shock eye, (turns out I had one already) and the new 3" and 4" numbers are...
39 replies | 3946 view(s)
-
02-15-2022, 09:47 PM
shorter lower shock eye, 1" gain there
new upper shock mount bracket to the chassis, 1" taller there
39 replies | 3946 view(s)
-
02-15-2022, 02:03 PM
just to update this thread, I called Rocket this morning and they're sending me the parts to give me another 2 in of travel on the right front. I...
39 replies | 3946 view(s)
-
02-14-2022, 04:16 PM
Good to know. I appreciate your patience with my "learning out loud" process here :)
39 replies | 3946 view(s)
-
02-14-2022, 02:47 PM
Slightly changing track .. from what I'm getting from Rocket Inc ... it appears there are a few different ways to get to the 3" and 4" load numbers...
39 replies | 3946 view(s)
-
02-14-2022, 02:45 PM
Right .. but what about 13 years ago when the blue/gray was first built ?
Dunno, just pondering.
39 replies | 3946 view(s)
-
02-14-2022, 02:17 PM
good to know. i'm very much a foam-donut kinda guy too. will be interesting to see how it goes.
8 replies | 1086 view(s)
-
02-14-2022, 02:02 PM
6" shock only has an 18.250 full extended pin to pin, maybe that's not enough shaft extension off ride height ?
39 replies | 3946 view(s)
-
02-12-2022, 10:42 AM
thanks masters .. that's exactly the kind of info I needed. I have a bump stop, will try that with the 200# spring and see if I can hit the 3/4"...
39 replies | 3946 view(s)
-
02-12-2022, 04:43 AM
yeah this is just kind of strange, it's not like I'm in some fringe set up here I can't be the first person to run into this.
39 replies | 3946 view(s)
-
02-11-2022, 11:44 PM
top and bottom cap on the bump spring need to be there, that's what locates it. yeah I guess I probably should go ahead and pull the travel...
39 replies | 3946 view(s)
-
02-11-2022, 11:41 PM
so all of that was premised on beginning at ride height and I think I've read in rocket's notes that they're not that concerned with ride height over...
39 replies | 3946 view(s)
- Date of Birth
- October 23, 1967 (54)
Total Posts
- Total Posts
- 538
- Posts Per Day
- 0.10
Visitor Messages
- Total Messages
- 1
- Most Recent Message
- 06-26-2012 11:35 PM
General Information
- Last Activity
- 07-21-2022 10:01 PM
- Join Date
- 06-12-2007
- Referrals
- 0
All times are GMT -5. The time now is 09:53 AM.
|
|
Find latest posts
07-15-2022, 11:25 AMNot sure. This one with water in it is a PowerMaster. I'd probably go the Toyota route next time I get one.4 replies | 438 view(s)