The frame on my car is bent in 2 different areas. One spot is on the right side framerail directly across from the 5th shock and it's bent in towards the center of the car. The other place is on the top right side framerail, by the RR; where it's bent up towards the deck with some angle to it but not much. The one spot by the RR seemed to have affected the ride height some. I drove the car with the frame bent a few times this year and it seemed to have not affected the handling of the car. Like I said, I had to adjust the ride height on all 4 corners to get it close again, and when I did that and put it back on the scales, nothing had changed. My question is, should I straighten the frame out on both locations, or just leave it alone? Keep this in consideration as well, the rear clip got twisted to the side slightly back in 2010 and I got it straigthened back out. So the frame has been bent twice. The only thing that worries me about straightening the frame out for the 2nd time, is will it make the welds and frame more weak, and will it affect the car on the scales? I'm assuming that if I had to adjust the ride height after it got bent, I would have to also adjust it again if I straighten the frame... I'd appreciate any opinions! I will upload pictures of the frame if someone could tell me how...