-
Bellhousing Depth.
I feel like this is a dumb question, but here goes. I have a Bert Bellhousing, and a ballspline trans. It seems like the trans input shaft bottoms out before the trans is up flush against the bellsousing.
what am I doing wrong here? Is there a different depth bellhousing? Can my input shaft be too long?
-
Do you have the midplate between the block and bellhousing?
-
I do have the midplate. Standard type. About 1/4"-3/8" thick. I have about 3/4" of spacer between the transmission and the bell. The round flange on the trans is nowhere near inside the bell like it should be.
-
Pilot bearing in the crank?
-
^^ Holy....I'll bet it is. Thanks.