Printable View
I am running coilovers on left and right // LR is in front and RR is in back lr is a 225 spring with no preload , and rr is a 175, preloaded 1.5in should this work.had LR and RR in front of rearend and had no side bit. and not much forward bit ..pan hard bar in rear..... biscuit bar 3 and 1 ..... what is the hot setup for coilover's with panhard bar behind rearend..thank for any help you guy's can give me...have not ran this setup yet what do you all think......help
Aren't coil overs illegal on sport mods???
not illegal here in ca.. we are not imca yet
I would put the LR spring behind the axle. Can you put the RR spring on the axle ? What kind of tires and pressures ?
cant put LR spring behind the axle panhard bar is there no room tire's g-60s rf14 rr12 lr8 lf10
Is this a three link car? If so, how you have the springs should work best (LR in front, RR behind). I don't understand what you mean by preload in the springs though. Just set ride heights, set LS and Rear %, then set your LR bite. Where they are after that is where they are. 100-130 LBS of Bite, 56-57% Rear, 52-53% Left (w/o driver, assuming 200lbs) should be a good starting place.
Spring rates look alright in rear. 550-650 range in the fronts assuming a Chevelle clip or Metric w/Nova lowers. 15-20* in left bar, 0-5* in right. Panhard bar 10* down to the right, mounted 3-4" below center of housing. Pull bar 15* down to the front. Soft shocks to let it move a little.