Jay dikens, vortec, world product heads, trades?

JAY DIKENS RACING ENGINES SBC STEEL TOP PROLINE HEADS 230 BEEN PORTED & FLOWED BACK AS UNTOUCHED CAST -FOR UNPORTED RULES, UP TO 600 LIFT ISKY FLAT TAP SPRINGS, 2.06 FERREA 6000 series ROLLER SPRING VALVES --STAINLESS & TITAINIUM VALVES, ANGLE MILLED DECK, 1.550 ROLLER RETAINERS & LOCKS, CHEATER HEADS, MADE ALMOST 600HP -8 RACES SINCE FRESH -COST OVER $3000 NEW --SELL $1800
----
VORTEC BOWTIE SBC STEEL HEADS, 2.02 FERREA VALVES, ANGLE MILLED DECK, RETAINERS & LOCKS NO SPRINGS -WAS SET UP FOR 1.450 FLAT TAP SPRINGS - 15 RACES SINCE FRESH-- COST OVER $1800 NEW --SELL $1000

---
WORLD PRODUCTS / DART SBC STEEL HEADS, 2.02 FERREA VALVES, ANGLE MILLED DECK-WORKS WITH FLAT TOPS OR DOMES,, 6 RACES SINCE FRESHENED -HAVE 1.250 SPRINGS, RETAINERS & LOCKS FOR THEM--COST OVER $800 NEW --SELL $400

10x 23deg hvh brodix raised runner sbc alum heads cnc ported & brodix intake ,best 23deg heads made -isky roller springs - 2.125 titainium valves, titanium 1.550 roller retainers & locks, t&d shaft rockers, 15 races on them since fresh , billet roller cam, moly push rods,,-cost over $7000 new sell or trade $3500

--------------------------------------------------------------------------------------------------------------------

15 deg brodix raised runner sbc alum (pontiac made for gm ) heads cnc ported & brodix intake with deck & intake spacer & new gaskerts -isky roller springs - 2.125 titainium valves, titanium 1.550 roller retainers & locks, t&d shaft rockers -arp head studs -2 races on them since fresh ,cost over $8500 new sell or trade $4000

--------------------------------------------------------------------------------------------------------------------

also have complete 362cu short block - lite weight older bowtie steel block, with billet mains ,bored for these 15DEG je dome pistons -set up for drysump or u can still run it wet sump - 6" honda journal h-beam rods, 3.520 callies lite weight 43lbs honda journal knife edge crank-drysump pan , billet roller cam, moly push rods, all balanced & ready to build - i was changing to the up stroke crank - but now goin to crate class !

-----------------------------------------------------------------------------------------------------------------

MANY OTHER PARTS : COMPLETE DRYSUMP FRT & REAR MNT SYSTEM - EXTRA DRYSUMP LINES , BUTLERBUILT TANK, COLMAN & 2 OTHER TANKS - 4 DRYSUMP PANS

MSD HEI SBC DIST MSD CAP ROTOR PICKUP


TRADES ACCEPTED : 604 CRATE MOTOR , ENCLOSED TRAILER, DUELLY, 4 WHEELER, NICE OPEN TRAILER ETC - LET ME KNOW WHAT U GOT

best way is to txt or call if u cant txt -- so we
can answer you - we dont get on here n check this
post much - in milton florida TXT OR CALL 850-426-2936 NO TIRE KICKERS PLZ! SERIOUS ONLY