Search:

Type: Posts; User: ThrowInDirt

Search: Search took 1.01 seconds.

  1. What year of regal or cut less compare to a monte carlo

    Looking to build another car
  2. Replies
    15
    Views
    3,911

    Hi-Temp silicone is what I use and have'nt had...

    Hi-Temp silicone is what I use and have'nt had any problems with it
  3. Replies
    3
    Views
    1,239

    I scale without...always have....some will say...

    I scale without...always have....some will say that its wrong and some will say its right...but it works for me
  4. Replies
    21
    Views
    8,430

    I used to buy them from speedway..But I went to...

    I used to buy them from speedway..But I went to Harbor Freight for something and found some disks that looked almost identical to the speedway ones...I bought 3 of them for like 15$..lol alot less...
  5. Replies
    5
    Views
    1,089

    This is just a starting point...The pan hard...

    This is just a starting point...The pan hard bar...the pinion side should be 8 inch's above ground and the chassis side 10 inch's above..that'll give you a 10 inch roll center and should be 10...
  6. Replies
    18
    Views
    3,168

    I dont know what you all run, But I run a...

    I dont know what you all run, But I run a modified so a limiting factor for them is the 8" wide tire. If I were running a late model or sprint car then yeah I would be trying to get the very most out...
  7. Replies
    18
    Views
    3,168

    I've never have had a Engine on a dyno before. I...

    I've never have had a Engine on a dyno before. I never felt the need too put it on a dyno. I build all my own engine's and dont have any have any problems with horsepower. This last season I ran down...
  8. Replies
    29
    Views
    6,197

    There both the same besides the burst pressure is...

    There both the same besides the burst pressure is different between the two...51060 is 270 psi and 51061 is 285 psi
  9. Replies
    29
    Views
    6,197

    There both the same besides the burst pressure is...

    There both the same besides the burst pressure is different between the two...51060 is 270 psi and 51061 is 285 psi
  10. Replies
    3
    Views
    1,243

    dont know about Advanced.. I just started using...

    dont know about Advanced.. I just started using intregra's last year and I like them.. everytime I've called them or left a e-mail they've always respond quik with answers
  11. Replies
    6
    Views
    3,297

    raise it for less body roll or lower it for more...

    raise it for less body roll or lower it for more body roll
  12. Replies
    4
    Views
    1,865

    I just used some round stock and welded a nut on...

    I just used some round stock and welded a nut on one and slid the net through and weld the other nut on. Than I just welded right to the top of the roll bar
  13. Replies
    6
    Views
    1,516

    3-link help

    I just bought a mod thats 3-link, Right now the LR has coil over behind the axle and RR has the coil on top of rearend. Should I leave it like this or should I put the springs on sliders.

    Also...
Results 1 to 13 of 13

All times are GMT -5. The time now is 04:15 AM.


Powered by vBulletin® Version 4.2.0
Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.