Search:

is there a certain sweet part number to get, and what servo is best 235 ? or ?

looking for ideas on which sweet , rack and pinion would be best for a 2013 mastersbilt Gen X

another question on a mine is a 2013 gen x question is about what spacers do you use between the inner tie rods and the rack

ok so if i,m running left side 34 " and 36 " right now and i go to a 35 " right side axle lenght will this tighten the car up on dry slick track corner entry off gas ?

what ar the proper axle lenghts for a older gen x 2008

courious to what spring smasher #s for a 2008 smack with gen x front end would be -steel block aluminum heads

and please explain left or right on the top or bottom

is it best to have the top angled forward or backwards in relation to the bottom of the fifth coil ?

so on an 2008 gen x approx amount of left rear drop is ?

do you raise the front and the rear of the engine when running a steel block ?

ok so if you dont have ballast weight in the car , to move ?

ok so what if you run a motown block, and your driver is heavy and your car weighs 2480 driver in --
do you still run the same springs and lift bar spring ? on a dry hard slick track that takes...

? $$$$$$$$$$$$$$$$$$$$$$$$$$$

what degree pistons are in the 430 short block ..

so what rotating assembly did it have in it

is the oil pan rail standard or wider ?

is this still availible ?

i run mine around 32 degrees total advance, and it works good ..

its a 1998 pontiac grand prix, no amp, if the fuse that runs the radio and heater etc are pulled , no draw

I have a parasitic draw on the battery. The only fuse that makes a difference when pulled is number 29 under the hood listed as Radio Bat (10 amp). When I pull that fuse the draw is gone, car will...

just a question what all is needed to switch from open engine rules to crate engines, as in what all does one need to get besides the engine its self ?

lol whacked

how does it prevent horsepower loss ?

thats a 2 inch round tube 2006 mastersbilt

how heavey should a masterbilt way in with a 280 pound driver steel motown block engine.aluminum headed though.