|
|
Search:
Type: Posts; User: car62
Search:
Search took 3.60 seconds.
-
-
-
On TFI the white wire from MSD box(crank trigger)gets hooked to green wire on TFI
-
Running the felpro 1035,ran engine for about an hour using head bolts,took head off(can't remember why),now using head stud kit,1035 looks perfect,safe to re-use it? Parts store is 5 days out on...
-
Definitely don't want washers between tube and pump,it will suck air...if you want more pressure,go with a Melling M127
-
I've ran it...assuming you are on asphalt?
-
Also check for bent balljoint
-
I've got one without the shifter
-
Still have 2 sets available
-
-
Racer Walsh certainly is open
-
have you considered going with a heavier clutch/flywheel combo?
-
go with a Melling M-127 pump, also check your main clearances...or just buy a motor from me,custom built to your specs!!!
-
yes oil will come gushing out,slow down the drill speed,all you are doing is priming the engine,just make sure you are going clockwise
-
could be sucking air somewhere,could be wront bearing tolerances, could be weak oil pump
-
Yeah,just shoot me a text at the number posted and I'll send a couple pics
-
2 sets gone, 2 sets still available
-
.630 lift billet cam
strapped towers
milled .100
Manley 1.79 valves
hardened seats
single wire beehive springs
titanium retainers
D-port close chamber,laid over at 45 degree angle and shaped...
-
14 sets on the shelf
$111 a set shipped to you(usa)
Text is best 208-625-1528
-
i have 4 brand new sets left
$160 a set shipped to you(usa)
Text is best 208-625-1528
-
ive run 38 degrees with a 5.7 rod 2.5 and never had an issue,ive also taken apart rods that the bearing was completely gone in and they were still proprly torqued, my guess is whoever assembled the...
-
when they discontinued the HP and replaced it with the XP it seems to have corrected alot of issues,the XP carb is so much more responsive than the HP on the exact same engine with same jets and PV...
-
Just a follow up, i found out the info i needed, it is referred to as a T-9 transmission and has a 2nd gear ratio of 1.81
-
Old Rob, i also sent you a PM on some lifter inserts
-
PM sent, for some reason when someone PM's me im not getting any email notification...anyone else having this issue?
All times are GMT -5. The time now is 09:16 PM.
|
|